If you are inexperienced with updating Eltron device drivers manually, we highly recommend downloading the Eltron P Driver Utility. However, support exists only for single side printing. Note that for proper seating the take-up cores of Lamination Ribbons have a slot that must align with a screw on the takeup spindle. To achieve a Gold competency level, Solvusoft goes through extensive independent analysis that looks for, amongst other qualities, a high level of software expertise, a successful customer service track record, and top-tier customer value. A card pass is used primarily to gauge Print Head life.

Uploader: Yozshull
Date Added: 20 February 2009
File Size: 61.57 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 14973
Price: Free* [*Free Regsitration Required]

Eptron Processes A sensor signals when the feeder rollers deliver a card to the card transport rollers. Refer to Section 2, Operation, for information on loading cards and ribbons and for initializing the printer for operation.

The card media should be matched to the ribbon type eltton avoid ribbon burning, sticking and to achieve proper dye sublimation. For Step 1 Lamination ribbons, the notched end of the empty core must face up. Ribbon Untape the end that fastens the ribbon end to Preparation the roll while leaving the tape attached on the Step 2 supply side.

Zebra Eltron P400/P500/P600 Card Printer Driver

Case removal exposes circuit points that, if touched with power on, can present a hazard. Sf Command – Synchronize Film overlaminate Ribbon Loading Lift open the cover. All other marks are trademarks or registered trademarks of their respective holders.


Tc Command – Set Temperature Printers may be ordered in any of the following standard configurations: If necesStep 3 sary, adjust the Card Gate for the card thickness. Gray-Scale Dye Gray scale imaging involves a single pass of Sublimation cards under the print head.

Then, using a medium Phillips screwdriver, remove p5000 eight screws that secure the back of the case. C Command – Set Coercivity Snap the opposite shaft pin of the roller into the hole on the Spring Tab. Mc Command – Clear Media Path Eltron warrants the print head and Laminator head, under normal use and service, to be free from defects in material and workmanship for a period of one year or 40, passes whichever occurs first from the date of purchase by the end user.

Never use pasted-on stripes. Note that the Install Printers Driver screen has text that specifies the Drivers Folder as the location of the driver file eltro be installed. The lower roller can be turned using the same procedure that produces test cards.

Eltron P dual-sided id card printer with lamination

T Command – Mag. Never attempt to vacuum particles off of the Print Head, as damage to delicate imaging elements can result. Either or both card side images eltrln be flipped.


Placing the switch in the ON 1 position applies power to the printer. The only user adjustable features of these card printers are made in software or programming and the card feeder gate adjustment see Section 2.

The electromechanical device, which contains elfron means for measuring distance traveled along a magnetic stripe, used to produce flux reversals at specified locations along the stripe. Change Ektron Density Resin images hold their color without the protection of overlay varnish. A Appendix C The Magnetic Encoding tab offers settings that apply when the selected print file contains encoding data see Section 3 examples using Windows driver.

Open the Cleaning Rollers printer cover. Printing with a reversed ribbon can damage the Print Head or make an extensive cleaning necessary.

Check boxes enable or disable duplex printing, data compression, and a preview of the image awaiting printing. Figure Rear Case Removed 14 Rev. The ribbon should stop with an overlay panel centered at the print head. Cleaning Turn off power, open the cover, and unlatch Laminator Rollers and raise the Elrton head.